With a piece of sand paper, clean the surface area where you will place your Protekto Safe.
|
Remove the instructions and adhesive tape from your Protekto Safe. Remove the inner tray with key. Insert and ice pick thru large holes in the surface & punch out rubber caps in small holes on each side.
|
After opening resin-epoxy bag, spread evenly over surface that you cleaned.
|
Mix & spread the two substances until you get a gray color.
|
Once the mixture has been spread evenly, place your Protekto Safe in the desired place, pressing and moving it from side to side.
|
Remove the box to make sure both surfaces are evenly covered with epoxy; then replace.
|
To place your box on a vertical plane, it is recommended to support it with a ruler fastened with masking tape.
|
To Prevent your Protekto Safe from sliding, place some strips of masking tape over the outer box cover to hold it in place.
|
If you are going to place your Protekto Safe on a ceiling surface, you can use a broom or something similar to keep it in place while it solidifies.
|
Let it set for 24 hours before you use your Protekto Safe.
|
To hold the bolts or screws to your screwdriver, use some semi-liquid adhesive.
|
To secure the bolts or screws, insert them thru the holes in the outer cover of the box & screw tight.
For a stronger hold of your box, it is recommended to use both epoxy & bolts or screws.
|